The SAFETYre system is operational as soon as the vehicle is turned on, when the vehicle pass 50Km/h, a light “bip” sound lets you know that all four wheel are operating properly.


Using the two-switch remote control, the operator can at all time read tire pressure, clear an alarm condition, adjust volume of the alarm messages or access the setup information.

A single click on the II switch will give you tire pressure, note that the pressure reading will only be valid after about 1 minute of driving.

A single click on the I switch is also used to clear one or several alarm conditions, once an alarm or warning condition is cleared it will not be repeated until the vehicle is stopped.

Combined pressure on the I and II switch allows you to enter advanced system setup functions. These functions allow you to define the nominal pressure (see operating manual (French only) for further specification)